“We made a total of three passes with hole openers,” said Baker. The crew also used the drills to open the hole to 48 in. (32.3 cm) bits to perform the pilot bore through sandstone and limestone, which took 12 days at an average depth of 60 ft (18.3 m). They set up the Vermeer D1000x900 on the Midland side of the bore path and used a Vermeer D500x500 on the exit side. Two drills for an efficient boreTo perform the bore as efficiently as possible, the crew decided to use a drill on each side with a planned intersection near the middle of the bore. Luckily, their Vermeer D1000x900 HDD could do the job. “We knew we could go the distance, and we also knew we would have a good hole to work with since it was in solid rock, but we had to make sure we had a rig that could pull that weight all back,” said Hard Rock Directional Drilling General Manager Cory Baker. It was the weight of the steel pipeline they worried about. They had recently wrapped up a longer bore in Kemah, Texas - 11 600 ft (3535.7 m). The Hard Rock Directional Drilling crew wasn’t intimidated by the length. called in Hard Rock Directional Drilling because the pipeline would go through Midland and cross two highways, stretching over 8400 ft (2560.3 m). The Fasken Oil and Gas team and general contractor Kingsley Constructors, Inc. The Midland bore was part of a 4.5 mile (7.2 km) long pipeline installed by Fasken Oil and Gas to carry oil, gas and water from wells to a Fasken facility. The Midland bore is a project that I’m sure no one at Hard Rock Directional Drilling will soon forget,” said Myers. ![]() But this particular job is memorable because it combined all of the traits that make a job challenging. ![]() “We work in rock all the time, and we’ve done a lot of long drill shots and opened up some pretty wide holes. That, and the fact that he employs highly skilled and trained crew members and provides them with the resources they needed to get the job done. (76.2 cm) diameter steel pipe in rock along a busy highway.Īccording to owner Robert Myers, planning was key to this job’s success. Using two Vermeer® horizontal directional drills (HDDs) and a pair of Vermeer reclaimers, the San Antonio-based HDD specialists could do more than some other crews – installing 8414 ft (2564.6 m) of 30 in. Everything is bigger in Texas, and the job Hard Rock Directional Drilling performed in Midland, Texas, proves it.
0 Comments
Leave a Reply. |